Minwax Wipe-On Polyurethane – Satin Oil-Based Finish, 1 Pint

Minwax Wipe-On Polyurethane is an oil-based clear finish you apply with a cloth instead of a brush. This is the 1 pint can in satin sheen. Wiping on thin coats gives the soft, hand-rubbed look of a traditional oil finish while building the protection of polyurethane against water, household chemicals, food stains and everyday wear.

Why wipe-on?

Brushing poly on furniture often leads to drips on edges, brush marks and dust caught in a thick wet film. Wiping it on puts down thinner coats that level easily and dry faster, and you control the build coat by coat. It is especially forgiving on turned legs, spindles, trim and carved details, where a brush tends to leave runs.

Working with it

• Start with a clean, dry surface sanded smooth. Use it on bare wood or over a properly prepared stain.
• Shake the can well.
• Pour a little onto a clean cloth and wipe on an even, thin coat.
• Recoat after 2-3 hours. Sand lightly between coats for a smoother final finish.
• Allow 24 hours after the final coat before light use.

One pint covers up to 62 sq ft, enough for a few furniture pieces, a run of cabinet doors or some paneling. The satin sheen brings out the grain and depth of the wood without the plastic look of high gloss. Clean up cloths and spills with mineral spirits.

Minwax has made wood finishing products since 1904.

Good to know: lay oil-soaked rags flat outdoors to dry, or soak them in water before you throw them out. Never leave them in a pile.