Leecraft CR-1 Zero Clearance Table Saw Insert for Craftsman/Sears – 14 x 3-3/4 in (Colors May Vary)

Overview

Elevate your table saw workflow with the Leecraft CR-1 Zero Clearance Insert. This accessory creates a blade-specific opening as you raise the blade through a machinable blank, helping to deliver cleaner cuts and a safer work zone. The insert is 1/2 inch thick, built from high-density phenolic laminate with a bonded-melamine surface. The combination emphasizes rigidity, flatness, and durability while maintaining low friction for smoother passage of wood and off-cuts. It’s designed to fit Craftsman (Sears) saws and is sized for dependable performance on busy shop days.

Key design features

The CR-1 is crafted for practical, repeatable setup. Top-accessible leveling screws let you dial in precise height with minimal effort, while lateral adjustment screws help maintain a vibration-free fit. A rear anti-lift pin (except JT-1) helps keep the insert seated during aggressive cuts, and a precut blade bottom pocket provides clearance for fully retracted blades and bevel cuts. Each unit ships with straightforward instructions and is intended for carbide-tipped blades only.

• Eliminates dangerous gaps around the blade where thin off-cuts can get wedged, aiding safer operation.
• Fits Sears Craftsman 10-inch belt-drive models from 1977 to mid-2004 (check size, see DL-1U); also compatible with RIDGID TS2412, TS2424, TS2400.
• Measures 14 by 3-3/4 inches with a 3/16 inch thickness; please measure before ordering.
• Offers superior rigidity, flatness, durability, and low friction; designed to reduce chip-out and splintering for cleaner edges.
• Note: CR-1 does not fit TS2400LS, TS2400-1, or the new TS2410 (see RG-2).

In practice, the CR-1 supports consistent blade alignment and slot sizing, which can contribute to steadier cuts and improved material handling. While performance can vary with blade type and project, the zero-clearance approach is intended to minimize tear-out and produce more predictable results. Colors may vary between product images, reflecting the materials and finish used in each batch.

Usage and compatibility at a glance

This insert is designed for Craftsman/Sears 10-inch belt-drive tables and selected RIDGID models when the size aligns with the 14 x 3-3/4 inch footprint. It emphasizes top-access leveling and a robust bottom pocket to support a range of bevel and retracted-blade applications. Always verify fitment against your saw’s model and dimensions before purchase.