Aquaboon 1 Micron Sediment Filter 10 x 4.5 — Whole House, 2-Pack, Compatible with DGD-5005 & AP810

Clear water start to finish

Rely on the Aquaboon 1 Micron Sediment Filter in a 10x4.5 inch cartridge for whole-house filtration. Built from 100% melt-blown polypropylene, this filter targets sediment, sand, silt, and rust to help your home water look and feel crisper. By catching fine particles before they travel through pipes and taps, it supports consistent flow and can help reduce downstream buildup while remaining compatible with a wide range of standard housings.

What you get in this 2-pack

• 1 micron filtration for fine particle control while preserving flow.
• Long replacement interval: up to 6 months or 30,000 gallons, depending on water quality and usage.
• Multi-layer design with gradient density for efficient particle capture across sizes.
• Universal 10" length and 4.5" diameter fits most whole-house housings.

Real-world use and daily impact

In homes with well water or variable supply, this filter helps reduce visible sediment and can contribute to smoother showering, clearer ice, and less frequent maintenance of downstream filters and appliances. It provides a practical layer of protection without promising specific outcomes, keeping expectations aligned with everyday use.

• High flow rate with low pressure drop supports steady water pressure across multiple outlets.
• Protects plumbing and appliances by reducing sediment and scale buildup over time.
• Broad compatibility with widely used housings makes upgrading or replacing straightforward.

Quality, durability, and installation basics

Crafted from durable melt-blown polypropylene, this cartridge is designed for reliable performance in a range of well water and filtration scenarios. For best results, flush new cartridges before use and verify seals after installation to minimize leaks. The 2-pack option offers ongoing value and reduced replacement effort.

Installation and care tips

• Shut off the water supply before replacing the cartridge.
• Pre-flush new filters for 1–2 minutes to clear loose fibers.
• Check o-rings and seals for wear and replace as needed.